![]() If on skin, remove contaminated clothing.If in eyes, immediately flush with running water for at least 15 minutes.If swallowed, seek medical advice immediately and show the container or label.Soak any clothes used in water immediately after use as they may self ignite.Store and use away from heat and eliminate any source of ignition. Brush on: Clean brushes and equipment with water immediately after use.To clean the nozzle after use and prevent blocking turn the can upside down and press button until only gas escapes.Aerosol: Overspray can be removed while still wet with White Knight Rust Guard Solvent.For heavy traffic areas, White Knight Glow Safe may be over-coated with White Knight Clear Guard to extend the life of the painted surface.Brighter lights and longer exposure will result in a brighter/longer glow time. Brightness and glow time is dependant on the film thickness applied, the ambient light level and the duration of exposure to light.Drying will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied.Brush on: Approximately 8m² per litre, depending on the nature of the surface.Aerosol: Approximately 1.5m² per can, depending on the nature of the surface and amount of overspray.Apply 1-3 coats by brush or roller, depending on glow time required.ĭo not use when air or surface temperature is below 15☌ or above 30☌ or in excessive humidity.Stir thoroughly with a broad flat stirrer in a circular lifting motion for at least 5 minutes before use and continue to stir at regular intervals during application.To prevent paint from sagging, avoid spraying too close to the surface or applying a heavy coat. Press button firmly and spray several light coats with a smooth sweeping motion, overlapping each spray pass.Hold the can upright approximately 25cm from the surface.To change the nozzle setting, turn the red section on the nozzle. ![]() Select the nozzle setting: The horizontal setting should be used when spraying up and down and the vertical setting should be used when spraying across.Avoid using sharp objects that may puncture the can. Shake can vigorously for 1 minute to ensure colour uniformity.Cover all necessary areas to protect from overspray.For other surfaces use an appropriate primer undercoat.Prime with White Knight Rust Guard® All Purpose Primer or Taubmans 3-in-1 Primer Sealer Undercoat as per label directions. Prime with White Knight Rust Guard® SLS Etch Primer as per label directions. Galvanised iron and non-ferrous metal (e.g. Prime with White Knight Rust Guard® All Purpose Primer or White Knight Rust Guard Metal Primer as per label directions. Apply one coat of Taubmans 3in 1® Primer Sealer Undercoat as per label directions. Apply one coat of White Knight Ultra Pave® White as per label directions. May be applied over any background colour, however a white background will provide the brightest glow.Treat any mould with suitable anti-mould solution.Fill nail holes and cracks with appropriate filler and sand smooth.Thoroughly sand glossy or enamel surfaces.Remove all loose rust and flaking paint. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |